(Peer Review + Similarity + Document) DESAIN TULANGAN DAN ANALISIS KOLOM BETON PADA PENAMPANG GAGAL TARIK DISAAT TULANGAN TEKAN TELAH LELEH SESUAI SNI 2847:2013

PRIYONO, PUJO (2020) (Peer Review + Similarity + Document) DESAIN TULANGAN DAN ANALISIS KOLOM BETON PADA PENAMPANG GAGAL TARIK DISAAT TULANGAN TEKAN TELAH LELEH SESUAI SNI 2847:2013. Universitas Muhammadiyah Jember, Universitas Muhammadiyah Jember.

	Text 6. USULAN PENYEDERHANAAN DESAIN TULANGAN DAN.pdf Download (1MB)
	Text 6 Peer Review.pdf Download (2MB)
	Text 6 Plagiasi DESAIN TULANGAN DAN ANALISIS KOLOM BETON PADA.pdf Download (3MB)

Abstract

In SNI 2847: 2013, the maximum reinforcement limitation requirement is no longer a constant
matter, but it depends on the type of reinforcing steel quality used in the design, because the
tensile strength of the tensile reinforcement steel ε_t ^ o in the conditions of the nominal
flexural strength must be greater or equal to 0.005.
In SNI 2847: 2013, the reduction factor value ∅ is determined based on the tensile strain value
in the outermost fiber that occurs, ε_t ^ o (Net Tensiile Strain, NTS). It can be explained that
the value of ∅ is distinguished by the time of the compression controlled section, the tension
controlled section and the transition area. If ε_t ^ o≤ε_y then the cross section is said to be
pressure controlled and the value of ∅ = 0.65, when ε_y <ε_t ^ o <ε_t then the section is in a
transition state and the value of Ø = 0.65 + (εt- (ε_t) ̅) (250 / [(0.005- (ε_t) ̅) × 100]}, and when
ε_t ^ o≥ε_t the cross section is said to be tension controlled, the value of ∅ = 0.9, with ε_t =
0.005.
The tensile failure section has a good degree of ductility, for the column section it occurs when
the eccentricity value of the axial force, e, is greater than the eccentricity value of the axial
force under equilibrium, eb. The rational analysis step is to do the trial and error method
The purpose of this study is to guide the design of the flexural and axial compression
reinforcement area which is in the tensile failure category when the compressive reinforcement
has melted as required by SNI 2847: 2013 with a simple step, two-sided reinforcement.
This study method basically reprocesses the basic formulas of reinforced concrete column
cross-sectional strength theory in the previous author and SNI 2847: 2013 in order to obtain
another formulation that can be used in general with the aim of making graphics that can be
used as a tool to simplify and simplify the design. the area of bending reinforcement. The study
has produced a general formulation and graphs that can be used for all types of steel grades and
concrete grades less than or equal to 28 MPa.

[error in script]

Item Type:	Peer Review
Subjects:	600 Technology and Applied Science > 620 Engineering > 624 Civil Engineering
Divisions:	Faculty of Engineering > Department of Civil Engineering (S1)
Depositing User:	Novan Agung | novanagung8@unmuhjember.ac.id
Date Deposited:	17 Apr 2021 01:37
Last Modified:	17 Apr 2021 01:37
URI:	http://repository.unmuhjember.ac.id/id/eprint/9443

Actions (login required)

View Item